Vendor (Seagate/Hitachi ) factory information Number of read and write commands whose size segment size = 45998 Local Time is: Wed Jul 7 04: 34: 30 2010 CDTīlocks received from initiator = 1967221471īlocks read from cache and sent to initiator = 804439119 Smartctl version 5.38 Copyright (C ) 2002- 8 Bruce Allenĭevice: SEAGATE ST3146855SS Version: 0002 # Ask the device to report its SMART health status or pending TapeAlert message # Type the following smartclt command to check disk behind /dev/sda raid:Īsk the device to report its SMART health status or pending TapeAlert message if any, run: This RAID device is made of 4 disks located in /dev/sg. So /dev/sda is one device reported as SCSI device. Sample outputs: /dev/sda -d scsi # /dev/sda, SCSI device You need to install Adaptec Storage Manager for your Linux distribution as per installed RAID card. # cat /proc/scsi/scsi Download and install Adaptec Storage Manager We can also use the cat command to see which disks of the RAID controller are accessible on Linux: Sample outputs: 81:00.0 RAID bus controller: Adaptec AAC-RAID (rev 09) Is my Adaptec RAID card detected by Linux? Use the following commands to find if RAID card detected and grab info about each disks. Linux Use smartctl To Check Disk Behind Adaptec RAID Controllers
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |